|
[Sponsors] |
September 1, 2006, 00:44 |
creating spline along existing line cell?
|
#1 |
Guest
Posts: n/a
|
Hello everybody: I want creating a spline along exisiting line cell to catch up. However the command 'splc' only operating interactinvely on screen. There is no other command wayaround. I plan to run a loop to chase up a line. What I doing this is because 'splin chase' functioning very badly, could not go along slightly charpen curves.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Creating a new case from command line | gregh | OpenFOAM Pre-Processing | 25 | November 14, 2013 07:38 |
Creating A Constant Pitch Helical Line In Gridgen | John Hinkey | Pointwise & Gridgen | 2 | August 5, 2007 00:01 |
matrxi line cell | guang ai | Siemens | 0 | April 14, 2005 00:59 |
Creating line/lake in dynamic mesh | J.W.Ryu | FLUENT | 0 | June 21, 2002 04:07 |
creating line for dispalying data ? | siswara dana | FLUENT | 6 | September 3, 2001 04:41 |