|
[Sponsors] |
December 4, 2007, 05:54 |
Boundary change problem
|
#1 |
Guest
Posts: n/a
|
can boundary vary from one type to another? for example,when I running star, can I change the model's boundary from inlet to wall,or some other similarityly change? thank you
|
|
December 4, 2007, 11:24 |
Re: Boundary change problem
|
#2 |
Guest
Posts: n/a
|
Do you want to change boundary types during a running simulation?
|
|
December 4, 2007, 12:20 |
Re: Boundary change problem
|
#3 |
Guest
Posts: n/a
|
If you're using STAR-CD, you should be able to do this using load steps. I don't know about STAR-CCM or CCM+.
|
|
December 4, 2007, 19:08 |
Re: Boundary change problem
|
#4 |
Guest
Posts: n/a
|
yes I want to change boundary types during a running simulation,but I don't know how can I do. actually,I want do it with STAR-CD.what is the mean when you said do it using load step?can you say in detail? thank you so much
|
|
December 4, 2007, 20:25 |
Re: Boundary change problem
|
#5 |
Guest
Posts: n/a
|
Details are provided in the Star User Guide. See Chapter 8 - Analysis Controls for Transient Problems.
|
|
December 4, 2007, 22:57 |
Re: Boundary change problem
|
#6 |
Guest
Posts: n/a
|
Thank you very much
|
|
December 11, 2007, 09:59 |
Re: Boundary change problem
|
#7 |
Guest
Posts: n/a
|
you can use subroutine to change the boundary type.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
change of boundary condition | Giacomo de Renzi | FLUENT | 9 | May 22, 2008 06:42 |
change boundary condition via UDF | gerhard zalusky | FLUENT | 2 | July 12, 2007 03:51 |
change boundary conditions | adrien | FLUENT | 3 | May 2, 2007 07:52 |
Change boundary with time (CCM) | James | Siemens | 1 | November 30, 2006 11:47 |
change of boundary conditions | luca | FLUENT | 2 | November 22, 2004 10:31 |