|January 24, 2011, 11:48||
Join Date: Jan 2011
Posts: 4Rep Power: 8
I am simulating a vessel being filled up via an inlet at the bottom and exiting at the top. I want to simulate the tank overflowing so have just set the top of the vessel as a flow-split outlet. I am simulating gravity and so have the top of the vessel as the reference point. The flow is turbulent and so I am getting reverse flwo messages at the outlet. To bypass this I have used a mesh extruder to extend the outlet. This has got rid of the reverse flows.
I am wanting to know how much affect this extended geometry has on the rest of the system, as it is extended vertically and so will be affected by gravity.
|Thread||Thread Starter||Forum||Replies||Last Post|
|GUI crash and simulation engine still running||RPJones||FLOW-3D||2||November 9, 2010 09:18|
|velocity profile export from a simulation onto another||sudhirlv||STAR-CCM+||1||September 12, 2010 18:57|
|(chtMultiRegionFoam) reducing gravity increase the simulation time !||openfoam1||OpenFOAM||7||March 10, 2010 10:41|
|Replacing mesh while running a simulation||akultane||CFX||1||November 15, 2009 14:46|
|Help: gravity in CFX||Dejun Jing||CFX||2||July 22, 2002 08:58|