|
[Sponsors] |
Doubt with a Pelton wheel simulation in Ansys Fluent. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 23, 2023, 12:41 |
Doubt with a Pelton wheel simulation in Ansys Fluent.
|
#1 |
New Member
Lucas Morado
Join Date: May 2023
Posts: 1
Rep Power: 0 |
Hello guys!
I'm currently doing a project using Ansys Fluent and I'm trying to simulate the jet of water. I've made a cylindrical rotating region around the turbine itself and then a box enclosure. Being this my first CFD project and my first time using Ansys, I'm having some trouble with the cell zone conditions, boundary conditions and mesh interfaces. I don' t know exactly how to proceed with the simulation setup and make the turbine rotate. Do I have to select the "Mesh motion" in either the cell zone of the rotating region or the boundaries? This may be a simple setup of a rotating wheel but I'm hard stuck here. Any help is greatly appreciated. Thanks you all! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Combustion Simulation ANSYS Fluent - There is no ignition delay | Rudolf Diesel | FLUENT | 1 | May 21, 2023 06:30 |
Ansys Fluent crashing when starting simulation | marccfd25 | FLUENT | 3 | July 27, 2022 09:02 |
Gravel bedform simulation by Ansys Fluent | sajacivil | FLUENT | 5 | April 11, 2020 12:02 |
Box Solar Cooker Simulation in Ansys Fluent | Mahmoud67 | FLUENT | 0 | November 8, 2018 23:56 |
Combustion Simulation ANSYS Fluent - There is no ignition delay | Rudolf Diesel | FLUENT | 2 | October 1, 2018 01:16 |