|
[Sponsors] |
July 1, 2012, 05:52 |
Porus Domain Modeling
|
#1 |
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 17 |
Could some one please clarify upon the following questions I had on the modeling of porus domains:
1. Is it required to resolve the boundary layer on the walls of a porus domain while meshing it ? 2. Does the fluid pass through the whole area of a Fluid - Porus interface. I mean is a Fluid - Porus interface similar to a Fluid - Fluid interface
__________________
Best regards, Santhosh. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
sample utility stops sampling once the line leaves the domain | Zymon | OpenFOAM | 1 | May 2, 2012 04:51 |
Defining Domain Interface | Saikiran | CFX | 1 | November 7, 2010 17:40 |
How can I increase Heat Transfer at Domain Interf? | B.Simon | CFX | 3 | October 28, 2008 18:53 |
Modeling porus material | Azam Syed | FLUENT | 2 | September 19, 2005 01:35 |