|
[Sponsors] |
![]() |
![]() |
#1 |
Member
Join Date: Aug 2012
Posts: 35
Rep Power: 14 ![]() |
Hi everyone,
I have a problem with Ansys workbench. I import my mesh into a CFX table and that automatically goes to the next stage in CFX pre. The units however are wrong, and so the whole scaling is way off. I have imported my mesh seperately into a CFX Pre file and there are no problems with scaling there. Any ideas how to fix this anyone? Also how can I get one value out of each CFX run and have it stored automatically in an Excel table? Many thanks, |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] 2-Way FSI meshing problem using ANSYS 13 workbench | john881129 | ANSYS Meshing & Geometry | 0 | January 9, 2012 01:19 |
Ansys workbench 12 and 12.1 | ACER | CFX | 0 | April 29, 2011 21:43 |
Workbench (CFX) bucket problem | njsavage | ANSYS | 0 | April 29, 2009 17:10 |
Problem importing GAMBIT mesh to Ansys geometry | David G. | CFX | 0 | June 19, 2005 06:01 |
problem in reading ansys file | satya bulusu | Siemens | 3 | November 27, 2002 03:29 |