|
[Sponsors] |
March 1, 2013, 11:50 |
help on phase change model needed
|
#1 |
New Member
Join Date: Sep 2010
Posts: 6
Rep Power: 15 |
I am doing a melting/solidification model using homogeneous binary mixture in CFX. I specified the material specific reference enthalpy per the latent heat and the momentum source in terms of Darcy equation for porous media as a function of velocity and mass fraction. The results I got always show a very low flow velocity on the order of about 1mm/s rather than about 100 mm/s in reality. I tried different momentum source terms or even nothing at all, and the flow velocity increases slightly but still on the order of mm/s. I have found papers using similar models although no details are inclded. What could I have done wong? I have been struggling with this for a long time. Your help is highly appreciated!
Best regards, Richard |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Thermal phase change set up problem | Danial Q | Main CFD Forum | 1 | July 10, 2014 14:41 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
phase change with CFX | aximefu | CFX | 5 | March 28, 2012 03:38 |
Help needed to model gas-solids flow | Juliana P | FLUENT | 3 | September 21, 2005 09:42 |
thermal phase change question | CFDflying | CFX | 1 | February 18, 2004 04:10 |