|
[Sponsors] |
April 17, 2013, 11:07 |
Wall boundary type + Fixed temperture
|
#1 |
New Member
Join Date: Apr 2013
Posts: 5
Rep Power: 13 |
Hi all !
I have a problem in posing a fixed temperature (Dirichlet boundary condition) on the No Slip Wall (Wall boundary type). In CFX-Solver Modeling Guide in section "2.7.5.2 Fixed Temperature" is said about heat flux (not constant temperature) and a reference to CFX-Solver Theory Guide is given. In CFX-Solver Theory Guide (Release 11.0) I find : "Static Temperature is specified at the wall boundary" BUT I can not find where should I specify this temperature (please, see attached file). Is it possible to pose a 1st type boundary condition on a wall in CFX? if yes, than Please explain me the steps I have to follow in order to pose a 1 type boundary condition on a No Slip Wall (Wall boundary type). Thank you in advance! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
LES supersonic free jet | martyn88 | OpenFOAM | 22 | April 17, 2015 06:00 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |