|April 17, 2013, 11:07||
Wall boundary type + Fixed temperture
Join Date: Apr 2013
Posts: 5Rep Power: 5
Hi all !
I have a problem in posing a fixed temperature (Dirichlet boundary condition) on the No Slip Wall (Wall boundary type).
In CFX-Solver Modeling Guide in section "184.108.40.206 Fixed Temperature" is said about heat flux (not constant temperature) and a reference to CFX-Solver Theory Guide is given.
In CFX-Solver Theory Guide (Release 11.0) I find : "Static Temperature is specified at the wall boundary" BUT I can not find where should I specify this temperature (please, see attached file).
Is it possible to pose a 1st type boundary condition on a wall in CFX?
if yes, than
Please explain me the steps I have to follow in order to pose a 1 type boundary condition on a No Slip Wall (Wall boundary type).
Thank you in advance!
|April 17, 2013, 13:49||
Join Date: Feb 2011
Location: Earth (Land portion)
Posts: 579Rep Power: 11
Under the tab boundary details, you can specify the fixed temnperature. You may first have to go to your domain and choose the thermal energy model, not isothermal.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||45||February 8, 2016 05:42|
|LES supersonic free jet||martyn88||OpenFOAM||22||April 17, 2015 06:00|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|Concentric tube heat exchanger (Air-Water)||Young||CFX||5||October 6, 2008 23:17|
|Problem with compile the setParabolicInlet||ivanyao||OpenFOAM Running, Solving & CFD||6||September 5, 2008 20:50|