|
[Sponsors] |
February 5, 2010, 15:53 |
Some help with the results, please
|
#1 |
New Member
|
Hi, I've been working on a CFD simulation on a pumps for some time now, but I have some doubts about the results I'm getting from it.
This is my process of calculation 1. make 3D model is SolidWorks 2. create the mesh in ANSYS 3. make a simulation boundary conditions ShearStress, MassFlow in, Static Preasure outlet (I put hier 0bar is this OK or shoul I put normal preasure???), and I use frozen rotor 4.finally after the calculations I use turbo macro Liquid Pump Performance to calculate the head and efficiency, (I get strange result for the efficiency anny ideas why????) 5. I repeat the calculations for 5-6 different flows and get head and efficiency and make Q-H and Q-eta diagrams in EXCEL . is this a good way to works is there an automated way to calculate more than one point at once and to get an automated Q-H diagram... - what is better for pumps Shear Stress or K-epsilon (turbulence model) what is reference radius and reference height in the Liquid Pump Performance calculation (I change them but nothing happends!) |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM - Validation of Results | Ahmed | OpenFOAM Running, Solving & CFD | 10 | May 13, 2018 18:28 |
Different Results from Fluent 5.5 and Fluent 6.0 | Rajeev Kumar Singh | FLUENT | 6 | December 19, 2010 11:33 |
wind tunnel results vs fluent | pixie | Main CFD Forum | 1 | August 20, 2009 08:02 |
validation of CFD results | andy | FLUENT | 0 | June 13, 2007 13:55 |
Problems with repeating results | Lee | Siemens | 4 | May 26, 2006 03:39 |