|
[Sponsors] |
Incorrect mass equation, ansys is still converging? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 7, 2014, 05:34 |
Incorrect mass equation, ansys is still converging?
|
#1 |
New Member
Join Date: Jan 2014
Posts: 2
Rep Power: 0 |
Hello all
atm i´m trying to simulate a water bath in which a specific mass flow enters through a injecting pipe (as you can see in the attached picture). While I was playing around with the boundary conditions, i realized that as far as I can estimate the conservation of mass in my bath is not given. As there are no openings and no outlets and the income mass flow is positive, I expected the solver to diverge. But still I got results. Due to I am new to ansys and cfx, i am wondering if there are any mistakes in meshing or the setup. Thanks in advance Pete Setup.jpg forum.jpg |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Some problem of "Qcriterion.mcr& | yuyuxuan | Tecplot | 9 | February 12, 2016 03:27 |
questions about species transport through walls | shuqin | FLUENT | 13 | April 9, 2014 02:42 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
source term for mass equation | MASOUD | FLUENT | 0 | July 8, 2010 00:45 |
mass flow rate in ansys. | arun | Main CFD Forum | 1 | January 11, 2002 13:13 |