|
[Sponsors] |
January 20, 2014, 22:49 |
Tangential Vector Tolerance
|
#1 |
New Member
George Wakeham
Join Date: Sep 2011
Posts: 5
Rep Power: 14 |
Hi I am doing simulation with a curved wall that has a velocity and I know that the velocity components have to be tangential.
But because for this particular geometry I don't have any information on it I just chose a velocity vector that suited most of the wall, and my idea to get around it (just for this case) was to increase the tangential vector tolerance in expert parameters however although I have chosen 35 degrees (which is higher than the max difference) it still comes up with the error Is there something else that has to be done? or is there a limit on this tolerance? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ActuatorDiskExplicitForce in OF2.1. Help | be_inspired | OpenFOAM Programming & Development | 10 | September 14, 2018 11:12 |
Radial velocity and tangential velocity on centrifugal fan, | johnnyp | FLUENT | 2 | May 24, 2013 07:10 |
Tangential velocity - Theoretical and the one used in different CFD softwares | maheshraj | Main CFD Forum | 1 | October 29, 2012 13:34 |
Problem with time average tangential velocity in swirl flow. | lakhi | FLUENT | 5 | July 18, 2012 16:28 |
Cyclone Tangential Velocity ... | Abdul | FLUENT | 2 | August 13, 2008 00:07 |