|
[Sponsors] |
April 8, 2014, 02:54 |
Streamline plot near wall of aerofoil
|
#1 |
New Member
Tom
Join Date: Oct 2013
Location: Auckland, New Zealand
Posts: 24
Rep Power: 13 |
Hi there
I am trying to plot streamline on an aerofoil in CFX post. As indicated in figure attached, the streamline plot has started from a line which is offset from the leading edge. However, as shown, the streamline does not fully resolve the near wall region of the aerofoil. Could anyone tell me how to fix this problem? Thanks Tom |
|
April 8, 2014, 07:29 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,830
Rep Power: 144 |
Have a look at the streamline termination parameters. One of them is probably terminating the streamline early.
|
|
April 11, 2014, 09:47 |
|
#3 |
Member
Join Date: Nov 2009
Posts: 49
Rep Power: 16 |
Hi; You can use a Surface streamline.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] mergeMeshes problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 3 | July 29, 2015 04:15 |
Wall Shear on concave plate | sherifkadry | CFX | 7 | April 26, 2013 10:07 |
Wall heat transfer coefficient -plot in post | Nav | CFX | 0 | June 23, 2008 05:31 |
Streamline plot. | Sham | FLUENT | 1 | September 16, 2005 04:13 |
Wall functions | Abhijit Tilak | Main CFD Forum | 6 | February 5, 1999 01:16 |