How to generate force historical file?

zkdkeen · April 21, 2014, 00:42

Hello everyone,
I am using terminal command line on Linux cluster to run cfx. Since there is no graphics, so I can not see the point monitor such as lift drag defined in cfxpre. Then I tried to find a way to output the force historical file, but it turned no good.
So, has anybody ever faced the same problem? Could cfx generate the monitor point in a file? And how?
Any suggestions will be appreciated!
Best regards.

ghorrocks · April 21, 2014, 04:41

You can setup linux to display graphics with x or mesa or lots of other options. There should be no reason you are limited to a command line.

You can load the results file on any machine (even a different OS) and load it into CFX-Monitor and export the data points you want. Alternately you can use cfx5mon on the command line to export it directly. Look up cfx5mon in the documentation for how to use this function.

zkdkeen · April 22, 2014, 08:18

Quote:

Originally Posted by ghorrocks

You can setup linux to display graphics with x or mesa or lots of other options. There should be no reason you are limited to a command line.

You can load the results file on any machine (even a different OS) and load it into CFX-Monitor and export the data points you want. Alternately you can use cfx5mon on the command line to export it directly. Look up cfx5mon in the documentation for how to use this function.

Ok,thank you!

April 21, 2014, 00:42	How to generate force historical file?	#1
zkdkeen Member Antoni Alexander Join Date: Nov 2009 Posts: 43 Rep Power: 17	Hello everyone, I am using terminal command line on Linux cluster to run cfx. Since there is no graphics, so I can not see the point monitor such as lift drag defined in cfxpre. Then I tried to find a way to output the force historical file, but it turned no good. So, has anybody ever faced the same problem? Could cfx generate the monitor point in a file? And how? Any suggestions will be appreciated! Best regards.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] OpenFOAM Installation for navalFoam	sachinlb	OpenFOAM Community Contributions	22	July 28, 2017 06:26
[swak4Foam] Swak4FOAM 0.2.3 / OF2.2.x installation error	FerdiFuchs	OpenFOAM Community Contributions	27	April 16, 2014 16:14
patch error OF v2.2.2 mac	hewei	OpenFOAM Installation	4	November 30, 2013 17:55
Version 15 on Mac OS X	gschaider	OpenFOAM Installation	113	December 2, 2009 11:23
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 15:00

April 21, 2014, 04:41		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,915 Rep Power: 145	You can setup linux to display graphics with x or mesa or lots of other options. There should be no reason you are limited to a command line. You can load the results file on any machine (even a different OS) and load it into CFX-Monitor and export the data points you want. Alternately you can use cfx5mon on the command line to export it directly. Look up cfx5mon in the documentation for how to use this function.