|
[Sponsors] |
July 3, 2014, 15:03 |
Translational Periodicity
|
#1 |
New Member
Alex
Join Date: Jun 2014
Location: Canada
Posts: 15
Rep Power: 11 |
Has anyone seen anything similar to what is shown in the attached images? Opposite faces of the porous cube that I created are specified with translational periodicity, but something strange seems to be going on with one of the faces in particular.
Does anyone know what would cause it to display like this? I have verified that all faces are identical to their opposite counterparts. Could it be a mesh-related problem? I don't even know if it's an error, it just looks different than usual and I'd rather double check before I start running a solution. I'm hoping it's just a rendering issue and will treat it as such for the time being. Thanks in advance. |
|
July 3, 2014, 18:38 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
Yes, it is probably just a rendering issue. If you have checked that your mesh is OK then you can ignore it.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Tetra/Prism Mesh with Translational Periodicity | siw | ANSYS Meshing & Geometry | 6 | March 26, 2020 15:16 |
Translational Periodicity | Clavigo | ANSYS | 1 | February 10, 2012 11:01 |
Translational Periodicity / Velocity Profile | sberez | CFX | 1 | November 15, 2009 17:29 |
Ensight 8.0 translational periodicity | Francesco | EnSight | 0 | May 16, 2006 19:40 |
translational periodicity | wasim | CFX | 0 | May 13, 2006 13:34 |