|
[Sponsors] |
boundary condition: problems with outlet at 0.99 atm when doing a trasient simulation |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Muhammad Umair
Join Date: Aug 2015
Posts: 24
Rep Power: 11 ![]() |
hi,,,,
i m facing the following problem in transient run ,,, ,,, | A wall has been placed at portion(s) of an OUTLET | | boundary condition (at 100.0% of the faces, 100.0% of the area) | | to prevent fluid from flowing into the domain. | | The boundary condition name is: Outlet. | | The fluid name is: LiquidWater. | | If this situation persists, consider switching | | to an Opening type boundary condition instead.,,, ,,,, ,,,, my problem is boiling in crucible,,, slightly vaccum is given at outlet,,,, 0.99 atm.... this is ok in steady but following error occour in transient |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,934
Rep Power: 145 ![]() ![]() ![]() ![]() |
||
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
CFX fails to calculate a diffuser pipe flow | shenying0710 | CFX | 7 | March 26, 2013 04:13 |
Outlet boundary condition for a heated tube flow | JinBiao | OpenFOAM Running, Solving & CFD | 0 | July 28, 2012 03:56 |
Setting Pressure outlet boundary for simulation of Radial impeller | Mukund Pondkule | Main CFD Forum | 1 | April 5, 2011 09:24 |
outlet boundary condition | neil | CFX | 1 | June 17, 2002 00:57 |