|
[Sponsors] |
Create volume in CFX post for analysis purposes |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 2, 2015, 09:37 |
Create volume in CFX post for analysis purposes
|
#1 |
New Member
Nicolas
Join Date: Mar 2010
Posts: 13
Rep Power: 16 |
Dear forum members,
I'm looking for a possibility to create a geometrically defined volume that I can later perform calculations on. Or to put it in other words, I want to create a rectangular cuboid within my fluid domain that I can refer to for additional calculations, e.g. calculate volume averaged properties. So in my fluid domain, I can create a volume via locations and limit this volume in one dimension (e.g. z-dimension). However, I can't add any more limitations regarding the x- and y-dimension. Any ideas how this can be done? I probably could create a group of iso clips from respective planes and average the results outside CFX, but this is not straight forward and not a “real” volume averaging, so I hope there is a better option. |
|
Tags |
post processing, volume, volume averaging, volume generation |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Errors during blockMesh meshing | Madeleine P. Vincent | OpenFOAM Meshing & Mesh Conversion | 51 | May 30, 2016 10:51 |
[GAMBIT] how do i split volume or create volume surrounding | pesar125 | ANSYS Meshing & Geometry | 1 | December 17, 2013 01:07 |
cfx post create a chart | turbodede | CFX | 0 | December 11, 2012 09:11 |