|
[Sponsors] |
Convergence problem with small opening in a valve |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Kiran
Join Date: May 2012
Posts: 6
Rep Power: 14 ![]() |
Hi
I am trying to analyses angle valve for small opening. I am facing convergence issue. I have modeled the 10 times the diameter at inlet and out let( upstream and down stream). Boundary condition Inlet Mass flow rate : 140 Kg/sec Outlet: Opening Pressure and Direction 100kPa. I have attached the RMS, CFX setu details and geometry details Thanks Kiran RMS.JPG CFX.txt GEo.JPG |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,781
Rep Power: 143 ![]() ![]() ![]() ![]() |
||
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
Kiran
Join Date: May 2012
Posts: 6
Rep Power: 14 ![]() |
Thanks Ghorroks
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
udf for valve closing a pipe using dynamic mesh | chem engineer | Fluent UDF and Scheme Programming | 2 | May 13, 2017 09:39 |
Submerged fin, Convergence problem | supermouniette | FLUENT | 10 | July 6, 2009 10:47 |
Convergence of CFX field in FSI analysis | nasdak | CFX | 2 | June 29, 2009 01:17 |
CONVERGENCE PROBLEM - oil boiler | MM | FLUENT | 1 | February 15, 2007 05:24 |
convergence problem with SIMPLER | NURAY KAYAKOL | Main CFD Forum | 1 | February 24, 1999 13:43 |