|
[Sponsors] |
April 5, 2016, 06:43 |
Problem with BC
|
#1 |
Member
|
I can not set results from analysis №1 to starting BC of analysis №2.
Solved rotating domain with propeller. 123456.JPG Than I must to set getting flow vectors on round surface before wing and solve it. 222.JPG 1) After meshing in ICEM, was lost round surface? 2) How set res from analysis №1 to surface in pre CFX? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |