|
[Sponsors] |
June 22, 2001, 13:28 |
Combustion in a sphere
|
#1 |
Guest
Posts: n/a
|
I am constructing a spherical vessel in which I will simulate combustion of methane and air (single phase). Ignition of the gas will be induced by raising the central spherical cell temperature to approx. 1100K.
So, my question is - can I use build where the north and south poles will cause possible problems for mesh analysis? Do you know a way around these N & S poles occurring? I am having major problems running meshbuild as it keeps crashing, and therefore prefer to use BUILD. regards Caz |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Modelling Combustion in Porous Zone | tanjinjack | FLUENT | 2 | September 26, 2016 04:10 |
hydrocarbon gases + Boron particle combustion | nileshjrane | OpenFOAM | 1 | December 13, 2010 06:20 |
Hydrogen Air combustion in a combustion chamber | popi | CFX | 7 | July 11, 2007 18:40 |
Need Similar Combustion Tutorial as my model | Arnab | Siemens | 0 | May 24, 2005 18:23 |
meshing F1 front wing | Steve | FLUENT | 0 | April 17, 2003 12:37 |