|
[Sponsors] |
August 23, 2001, 06:50 |
Help.. Particle Transport....
|
#1 |
Guest
Posts: n/a
|
Hi
I have an error message, 'you must set the velocity on the patch -three components are needed' But I set the Velocity on patch.. Here's the part of my fo file... >>PARTICLE TRANSPORT BOUNDARY CONDITIONS >>PARTICLES ON PATCH PATCH NAME 'INLET-2' DIAMETER DISTRIBUTION TYPE 'UNIFORM IN DIAMETER' NUMBER OF SIZES 1 EACH CELL CENTRE NUMBER OF POSITIONS 1 TOTAL MASS FLOW RATE ON PATCH 1.2000E-01 VELOCITY ON PATCH 1.200000E-01 MASS FRACTION1 ON PATCH 1.0000E+00 >>PARTICLES ON PATCH YOU MUST SET THE VELOCITY ON THE PATCH - THREE COMPONENTS ARE NEEDED THE CFX-4 SOLVER HAS BEEN STOPPED BY SUBROUTINE CMDPBC sorry for my poor english.. Thanks. |
|
August 23, 2001, 10:33 |
Re: Help.. Particle Transport....
|
#2 |
Guest
Posts: n/a
|
You will need to set the velocity as a 3-d Vector.
i.e. VELOCITY ON PATCH U V W. If you want it in just one direction, you will have to use VELOCITY ON PATCH U 0 0 |
|
August 23, 2001, 19:55 |
Re: Help.. Particle Transport....
|
#3 |
Guest
Posts: n/a
|
Thanks for your response...
Yim. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Particle transport and deposition & Drift Flux Model | Peter023 | Fluent UDF and Scheme Programming | 3 | April 20, 2021 23:50 |
DPM UDF particle position using the macro P_POS(p)[i] | dm2747 | FLUENT | 0 | April 17, 2009 01:29 |
particle transport model | Fabiana | CFX | 0 | January 10, 2006 15:00 |
Particle transport model! | Danney | CFX | 2 | April 15, 2003 02:24 |
convergence in particle transport model | Jose Tinoco | CFX | 0 | March 3, 2003 03:10 |