|
[Sponsors] |
August 31, 2001, 03:59 |
Manipulating the .geo file
|
#1 |
Guest
Posts: n/a
|
Hi everyone!
I'm trying to write a .geo file for CFX on my own. I'm starting out with a simple cubical geometry (1 block). The .geo file is basically simple enough to create, but I have a question about the PATCHES section. I created 7 patches (1 inlet, 1 outlet, 4 walls and 1 fluid). For each patch, I have to specify a direction (it takes values between 0 and 6). Does anyone know what this value stands for??? Thanks a lot. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1.7.x Environment Variables on Linux 10.04 | rasma | OpenFOAM Installation | 9 | July 30, 2010 04:43 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
gcc and executable file from Mac to Linux | simone Marras | Main CFD Forum | 0 | April 8, 2007 15:49 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |