|
[Sponsors] |
February 18, 2002, 10:30 |
Boundary conditions
|
#1 |
Guest
Posts: n/a
|
Hi
I was wondering if anyone knows how you apply more than one boundary condition such as velocity to one surface. Another question, if I draw a geometry with the full 360 degrees but only want to simulate over 90 degrees, do I redraw only 90 degrees or is a way of specifying over what portion you want to carry out a simulation. Jennifer |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
symmetry boundary conditions in cfx | lost.identity | CFX | 41 | May 22, 2013 07:21 |
OpenFOAM Variable Velocity Boundary Conditions | NickolasPl | OpenFOAM Programming & Development | 2 | May 19, 2011 05:37 |
[Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 09:38 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |