|
[Sponsors] |
August 29, 2017, 05:44 |
Aeration Tank Simulation
|
#1 |
New Member
|
Im running the simulation using cfx to find the pressure of the air and water acting on the bio-media inside the aeration tank. The bio-media is fully submerged into water where there is no water inlet or outlet. Air entered the reactor at the speed of 1 m/s from bottom to top. There is negative pressure acting on the bio-media. According to my supervisor, there should not be any negative pressure. I tried so many changes to the setup but still having the same problem. Im hope someone can help me Thank you in advance.
|
|
August 30, 2017, 06:55 |
|
#2 |
Senior Member
Maxim
Join Date: Aug 2015
Location: Germany
Posts: 415
Rep Power: 12 |
why don't start with posting screenshots of your setup, your mesh and attach your *.ccl file? Your chances for an answer and help will be much higher that way.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Request steps for aeration pattern study in steady water tank | Puni1993 | CFX | 4 | March 30, 2017 01:01 |
Simulation of thermocline in a tank | fkhan7 | CFX | 25 | October 22, 2015 11:23 |
regular wave tank simulation | pedrin84 | FLUENT | 3 | October 22, 2012 09:25 |
Roll Tank Simulation | Sam | CFX | 14 | February 15, 2009 20:21 |
simulation of a stirred tank | hu | CFX | 0 | February 17, 2001 07:23 |