|
[Sponsors] |
November 20, 2002, 03:26 |
2D mesh
|
#1 |
Guest
Posts: n/a
|
Hi!
Does anyone know how to make a 2D mesh in CFX 5.5 (Build) for an axisymmetrical round jet impinging on a flat plate? /Eva |
|
November 20, 2002, 10:53 |
Re: 2D mesh
|
#2 |
Guest
Posts: n/a
|
set the env variable for the 2D mesher (check for its name with your support engineers), start build, define a sector model with periodic boundaries on each side (that will be used to map the mesh from one side to the next to realise a 2D slab) and mesh. You should see the 2D mesh alg start in the Patran command line.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Meshing aifoil in ICEM | student123a | ANSYS Meshing & Geometry | 13 | December 8, 2010 10:40 |
mesh missing after export in gambit | morteza08 | ANSYS Meshing & Geometry | 1 | July 26, 2010 01:10 |
2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 04:49 |