|
[Sponsors] |
March 3, 2003, 07:33 |
Counter rotating wall
|
#1 |
Guest
Posts: n/a
|
I am modelling a rotor stator cavity.I have modelled the fluid domain as rotating in this I have mentioned the rotor wall as stationary no slip boundary and for stator wall as Counter rotating wall boundary.Is it correct or I have to change the boundary condition.can any body clarify the doubt.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to set rotating wall as boundary condition | babu | FLUENT | 7 | December 14, 2013 04:48 |
Rotating Impeller | Naith | FloEFD, FloWorks & FloTHERM | 22 | November 5, 2012 08:53 |
Patches for OpenFOAM 1.7 on MacOS X | gschaider | OpenFOAM Installation | 101 | September 21, 2011 05:37 |
Rotating wall transient signal in CFX | tiguiblais | CFX | 0 | April 23, 2010 14:11 |
rotating wall / mesh motion | actone | CFX | 2 | September 5, 2006 02:18 |