|
[Sponsors] |
November 11, 2017, 00:28 |
Errors while running the simulation
|
#1 |
New Member
Somashekhar Kulkarni
Join Date: Oct 2017
Posts: 14
Rep Power: 8 |
I tried to run a simulation to analyse the effect of non condensable gases on wall condensation of steam in a containment. The simulation runs for around 50-60 time steps (0.01s each) and then gives errors. I've attached images of the same below. Could someone help me with their meaning?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transient simulation not converging | skabilan | OpenFOAM Running, Solving & CFD | 14 | December 16, 2019 23:12 |
Slow Running Simulation | rsoni451 | CONVERGE | 10 | September 15, 2017 09:20 |
Help running SST k-omega Stress-Blended Eddy Simulation | DA6righthand | FLUENT | 0 | July 15, 2017 10:44 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
Replacing mesh while running a simulation | akultane | CFX | 1 | November 15, 2009 13:46 |