|
[Sponsors] |
May 11, 2003, 11:00 |
Mixing time:Tracer disappearing
|
#1 |
Guest
Posts: n/a
|
Hi All, I want to calculate the mixing time is an agitated vessel using CFX4.4. I introduced the tracer as a pulse input, where I expect the concentration of the tracer at a monitoring point to increase with time up to a maximum, and this should mark my mixing time. However, in my case the concentration of the tracer at the monitoring point, which is far away from the input point, increases then decreases continuosly up to the end of my iterations (12,000).
Where does this tracer go? regards nyatoto |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mixing plane model: too much backflow and does not converge | sbhi | FLUENT | 1 | December 4, 2014 00:31 |
Problem with Mixing plane | Mitpostdoc | FLUENT | 0 | July 26, 2011 14:31 |
Meshing a Mixing Plane in ICEM | Will Anderson | ANSYS Meshing & Geometry | 2 | November 9, 2010 09:16 |
Meshing a Mixing Plane using ICEM | Will Anderson | FLUENT | 0 | November 6, 2010 17:08 |
Mixing plane geometry definition | Hbet | FLUENT | 0 | January 18, 2002 07:16 |