|
[Sponsors] |
June 2, 2003, 03:50 |
GGI interface and meshing
|
#1 |
Guest
Posts: n/a
|
Hi everybody, I try to simulate the heat transfer in the roof of a road tunnel during a fire. Because of this, I use different imported domains with different kind of mesh. My problem is that on an interface between a cubic mesh and an irregular mesh, I have differences of velocity and temperature fields, specially where I have important gradient. I think the problem comes from the differences between the size of the elements of each part and I like to know how elements have to be at an interface to keep a good continuity of fields. Thanks.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mergePatchPairs for a meshing with fixed interface | Cyp | OpenFOAM Meshing & Mesh Conversion | 17 | May 22, 2014 09:34 |
[Commercial meshers] non conformal interface, meshing, inverted volume | araghunath | OpenFOAM Meshing & Mesh Conversion | 1 | April 7, 2011 04:27 |
Multiregion meshing with interface in between regions | bhaskar | STAR-CCM+ | 2 | June 23, 2009 06:06 |
Meshing around domain interface | Tom S | CFX | 0 | August 1, 2008 05:31 |
Dynamic meshing at phase interface | Scotia | FLUENT | 0 | March 3, 2008 12:55 |