|
[Sponsors] |
Validating centrifugal pump performance (important) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 21, 2018, 15:18 |
Validating centrifugal pump performance (important)
|
#1 |
New Member
Joseph M
Join Date: Nov 2017
Posts: 24
Rep Power: 8 |
Hi,
I am currently validating a pump with the following parameters: 1. rpm: 1450 2. Q=50 m3/h 3. Density= 1000 kg/m3 4. Head rise= 14 m 5. Exit blade angle= 27.5 degrees I have used CPD and Bladegen then Turbomachinery to carry out the meshing. However, when carrying out the procedure on CFX Pre, I am not able to get the HUB OUTBLOCK nor the HUB Downstream when setting out the boundary conditions. Could there be something wrong with my CPD design? Link to Journal article: http://docsdrive.com/pdfs/sciencepub...07/718-724.pdf |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Centrifugal pump performance analyzing | Vinothrengaraj | CFX | 2 | May 4, 2016 02:47 |
Partload Performance Centrifugal Pump In CFX | **Anny** | CFX | 4 | June 22, 2015 09:48 |
centrifugal pump | Chalghoum | CFX | 18 | April 16, 2014 06:37 |
Centrifugal Pump Cavitation problem or not. | ismael.s | CFX | 13 | February 27, 2012 08:00 |
[GAMBIT] influence between angle in impeller blade and centrifugal pump performance | barak182 | ANSYS Meshing & Geometry | 2 | August 18, 2010 03:07 |