|
[Sponsors] |
February 25, 2004, 01:08 |
Coil
|
#1 |
Guest
Posts: n/a
|
Hello there,
I have got 2 questions.. 1) Whats the easiest way to make a coil geometry? 2) If I have to model 2 fluid flows, one is inside the coil and ther other one is outside the coil to calculate the heat transfer...(they are not mixing) can I do that at the same time? I have access to icem, ansys, CFX 5.6 American larki |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Spiral coil heat exchange | luznyr | FLUENT | 0 | August 11, 2011 23:57 |
[Other] Mesh generation method for coil heated within shell | Asghari_M | ANSYS Meshing & Geometry | 0 | June 8, 2011 08:03 |
Two or Three Dimensional for a coil | Asghari_M | ANSYS Meshing & Geometry | 0 | June 7, 2011 05:28 |
Geothermal ground coil | jojo008 | ANSYS | 0 | April 13, 2011 03:22 |
heat transfer: air in a room and water in a coil | Alberto | CFX | 2 | May 9, 2006 09:56 |