|
[Sponsors] |
June 19, 2018, 14:53 |
Material Table Generation
|
#1 |
Senior Member
Pedro Oliveira
Join Date: Feb 2018
Location: Portugal
Posts: 109
Rep Power: 8 |
I have defined a material with table generation and I´m sure the pressure and temperature minimum and maximum values are accurate.
However in some iterations and some points the values of pressure or temperature are out of bounds, just for a little amount of time. Is it better to let the solver do clipping or should I activate pressure and temperature extrapolation? What is the difference between these too? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Setting the height of the stream in the free channel | kevinmccartin | CFX | 12 | October 13, 2022 21:43 |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Ansys CFX problem: unexpected very high temperatures in premix laminar combustion | faizan_habib7 | CFX | 4 | February 1, 2016 17:00 |
error message | cuteapathy | CFX | 14 | March 20, 2012 06:45 |
Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |