|
[Sponsors] |
June 19, 2018, 14:53 |
Material Table Generation
|
#1 |
Senior Member
Pedro Oliveira
Join Date: Feb 2018
Location: Portugal
Posts: 109
Rep Power: 8 |
I have defined a material with table generation and I´m sure the pressure and temperature minimum and maximum values are accurate.
However in some iterations and some points the values of pressure or temperature are out of bounds, just for a little amount of time. Is it better to let the solver do clipping or should I activate pressure and temperature extrapolation? What is the difference between these too? |
|
June 19, 2018, 18:38 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,705
Rep Power: 143 |
If it clips early on but as it converges it goes back inside your limits then I would not worry about it, it should be fine.
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
June 19, 2018, 21:00 |
|
#3 |
Senior Member
Pedro Oliveira
Join Date: Feb 2018
Location: Portugal
Posts: 109
Rep Power: 8 |
I will change some variables in my simulation in order to study the influence they have on results, if then the clipping is continous should I opt the extrapolation?
|
|
June 20, 2018, 02:17 |
|
#4 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,705
Rep Power: 143 |
If the final result clips then you can extrapolate, but a better approach would be to extend your table to cover the range your simulation is covering.
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Setting the height of the stream in the free channel | kevinmccartin | CFX | 12 | October 13, 2022 21:43 |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Ansys CFX problem: unexpected very high temperatures in premix laminar combustion | faizan_habib7 | CFX | 4 | February 1, 2016 17:00 |
error message | cuteapathy | CFX | 14 | March 20, 2012 06:45 |
Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |