 |
 |
 |
|
|
|
[Sponsors] | ||||
January 31, 2005, 19:28
|
Expert parameter "include pref in forces"
|
#1 |
|
Guest
Posts: n/a
|
Hi, I would like to know more detail information, about the expert parameter "include pref in forces", since the description offered in the CFX5.7's manual doesn't help much.
Thanks, Luis Prieto |
|
|
||
|
February 1, 2005, 17:02
|
Re: Expert parameter "include pref in forces"
|
#2 |
|
Guest
Posts: n/a
|
Hi,
Doesn't it just mean that without the parameter the forces on surfaces is calculated assuming a pressure of pref behind them, or with the parameter it is assumed there is zero pressure behind the surfaces? I am not sure, but a quick check run of CFX would prove it. Glenn Horrocks |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| expert parameter | sometimes1900 | CFX | 3 | October 27, 2008 12:41 |
| Expert parameter to stop the fluid flow simulation | KK | CFX | 1 | February 25, 2008 17:29 |
| MAxium residual...confusion with expert parameter | KK | CFX | 3 | February 8, 2008 11:47 |
| asking for a few expert parameter for rotarywing | charles | CFX | 4 | November 3, 2006 15:15 |
| Expert Parameter for compressible transient | ioannis | CFX | 0 | November 2, 2005 20:28 |
Linear Mode
