|
[Sponsors] |
March 10, 2005, 09:08 |
Node values problems
|
#1 |
Guest
Posts: n/a
|
I do a transient conduction analysis(about 200 run steps and residual target is 1E-4). There're two domains, inner and outer.(the inner one is fully inside the outer one)and the mesh nodes are fully matched at interface(created by ICEM_CFD simultaneously). I export both the domains' temperature data and I found that the temperature at interface nodes are slightly different in different domain!For example: for inner domain x1,y1,z1 359.4359 DegC . . for outer domain x1,y1,z1 359.4285 DegC (note: same coordinate) The temperature should be same for the same node in different domain, right? Thanks for response.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
CFX problems with supersonic inlet condition - Inlet values in CFX-Post are wrong | jannnesss | CFX | 5 | February 25, 2011 16:24 |
Master node in parallel computing only distirubtion | syadgar | FLUENT | 1 | September 8, 2009 16:41 |
Values of k and e for multiphase problems!! | zack | FLUENT | 0 | January 28, 2006 02:16 |
Node values on UDF??? | Kamal | FLUENT | 1 | December 10, 1999 10:37 |