|
[Sponsors] |
August 9, 2005, 18:52 |
Inflation
|
#1 |
Guest
Posts: n/a
|
Hi, All
I try to use inflation in meshing. The problem I got is that I can only creat inflation layers on certain faces in my geometry. If I choose more or all the faces, it did not show error but gave me no inflation layers. I tried many times but still haven't figure out the rules of using inflation. Can someone help provide me some tips on using inflation? Is it possible/necessary to generate inflation layers on all faces? Thanks Best regards! Gab |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Total Thickness of Inflation Layer | prikeyma | CFX | 5 | August 28, 2020 03:22 |
Add inflation on a laminar flow | xyq102296 | ANSYS Meshing & Geometry | 0 | October 21, 2010 07:37 |
Large Valve Flow Analysis - Inflation Problem | sercan85 | ANSYS Meshing & Geometry | 2 | June 1, 2010 14:02 |
question about inflation for impeller | sandy | CFX | 4 | August 8, 2007 09:03 |
inflation | Jennifer Haque | CFX | 2 | June 9, 2004 18:55 |