|
[Sponsors] |
![]() |
![]() |
#1 |
Member
newansysuser
Join Date: Oct 2010
Posts: 33
Rep Power: 14 ![]() |
I am new to ansys software, I am building a simple model
a vertical cylinder, but on the wall I want to add inflation to refine the mesh, I saw sth. about Y+, but it is for turbulance model ,right? so what kind of regulation shall I follow when I try to add inflation boundary on the wall? Is there any forumlas for the inflation length scale? |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boundary Layer of Laminar Flow over a Flat Plate | Blasius_Pohlhausen_Crocco | Main CFD Forum | 12 | September 30, 2013 18:35 |
Nusselt numbers for fully developed laminar flow | Danro | Siemens | 8 | July 19, 2012 08:22 |
How to enforce laminar flow while using k-e | Grzegorz Kondora | FLUENT | 0 | January 28, 2009 11:35 |
a laminar flow and heat transfer problem | majestywzh | FLUENT | 1 | April 16, 2003 04:39 |
grid for laminar flow | kim | FLUENT | 2 | April 4, 2002 03:44 |