problem with analysing pressure in suction cup(weird pressure)

mitchell32 · March 7, 2019, 12:25

Hey guys,

I'm currently analyzing a pressure distribution in a suction cup with ANSYS CFD but here is the problem. The inlet pressure is 100kPa and the outlet pressure is 70kPa but the simulation is saying that the pressure inside the cup will be like something GPa and I just can't find out what I have done wrong.
here are the result and the report. can you maybe help me with finding the problem? setting is in the pic and mesh was done by automatic mesh

12.PNG

13.PNG

21.PNG

ghorrocks · March 7, 2019, 16:19

Your simulation is diverging. If you have not got an overflow error yet, you soon will. Here is the FAQ on overflow errors: https://www.cfd-online.com/Wiki/Ansy...do_about_it.3F

Mesh quality is going to be a big contributor here. Also you probably will need a compressible flow model.

evcelica · March 7, 2019, 16:24

Your mesh is most likely garbage.
Where is your inlet at?

March 7, 2019, 12:25	problem with analysing pressure in suction cup(weird pressure)	#1
mitchell32 New Member HK Join Date: Mar 2019 Posts: 1 Rep Power: 0	Hey guys, I'm currently analyzing a pressure distribution in a suction cup with ANSYS CFD but here is the problem. The inlet pressure is 100kPa and the outlet pressure is 70kPa but the simulation is saying that the pressure inside the cup will be like something GPa and I just can't find out what I have done wrong. here are the result and the report. can you maybe help me with finding the problem? setting is in the pic and mesh was done by automatic mesh 12.PNG 13.PNG 21.PNG

March 7, 2019, 16:19		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,709 Rep Power: 143	Your simulation is diverging. If you have not got an overflow error yet, you soon will. Here is the FAQ on overflow errors: https://www.cfd-online.com/Wiki/Ansy...do_about_it.3F Mesh quality is going to be a big contributor here. Also you probably will need a compressible flow model. __________________ Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind tunnel Boundary Conditions in Fluent	metmet	FLUENT	6	October 30, 2019 12:23
question regarding LES of pipe flow - pimpleFoam	Dan1788	OpenFOAM Running, Solving & CFD	37	December 26, 2017 14:42
Periodic flow using Cyclic - comparison with Fluent	nusivares	OpenFOAM Running, Solving & CFD	30	December 12, 2017 05:35
Two pressure inlets problem	Medison	CFX	1	August 22, 2012 06:50
Hydrostatic pressure in 2-phase flow modeling (long)	DS & HB	Main CFD Forum	0	January 8, 2000 15:00

March 7, 2019, 16:24		#3
evcelica Senior Member Erik Join Date: Feb 2011 Location: Earth (Land portion) Posts: 1,167 Rep Power: 23	Your mesh is most likely garbage. Where is your inlet at?