|
[Sponsors] |
Why there is a hole in my structure by using ICEM |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 21, 2005, 05:31 |
Why there is a hole in my structure by using ICEM
|
#1 |
Guest
Posts: n/a
|
Hallo,
Need everyone's help. I would like to draw a Laval nozzle (2D)using ICED CFD. I use the commands "point", "Curve" to construct it, but when doing the meshing, the message " there is a hole in the structure" appeared. Why? Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help: export 2-dim structure mesh from ICEM to CFX | guest7777 | CFX | 8 | November 11, 2010 12:05 |
New ANSYS forum structure, what do you think? | Peter | FLUENT | 10 | February 6, 2009 04:07 |
New ANSYS forum structure, what do you think? | Peter | CFX | 5 | February 4, 2009 11:59 |
ICEM CFD support 3D structure from AUTOCAD | Ho | CFX | 6 | October 6, 2005 23:16 |
a hole in my structure after meshing a nozzle | Ho | CFX | 7 | October 3, 2005 08:33 |