[Goenitz]

Good day,

I have inlet condition Tin 793K, Pin 1 atm, Vin 0.1 m/s and inlet size is 3.1X1mm.

The mixture is multi-component and its density is 227g/m3. Corresponding mass flow rate is 7.0565E-8 kg/m3.

For both velocity and mass flow rate inlet (Min) conditions, velocity profile is same with <5% error. But pressure is around 1 Pa in CFX post.

Why cannot I get ~ 1atm pressure?

P.S Absolute pressure is set 1 atm (it is just reference) and in 'material' tab, reference temperature and pressure are STP (also just reference as CFX theory guide).