|
[Sponsors] |
April 24, 2006, 11:22 |
Problems with "Refinement"
|
#1 |
Guest
Posts: n/a
|
Hello everybody!
I am simulating an 3D air flow through a brush seal in a steam turbine. I try to refine my mesh in particular locations. For this i use the function "Refinement" to increase the dense in two directions. When I try to write a solver file for CFX5 I always get following error message: Error: Running ICEMCFD - CFX5 Interface Vers. 5.1.1 child process exited abnormally Running ICEMCFD - CFX5 Interface Vers. 5.1.1 child process exited abnormally while executing "exec C:/Programme/AnsysInc/v90/icemcfd/5.1-win/icemcfd/output-interfaces/cfx5-dom./hex.uns-b./family_boco.fbc-ascii-internal _faces./cfx5" ("eval"body line 1) invoked from within "eval exec $args" (procedure "ic_exec" line2) invoked from within "exec C:/Programme/AnsysInc/v90/icemcfd/5.1-win/icemcfd/output-interfaces/cfx5-dom./hex.uns-b./family_boco.fbc-ascii-internal _faces./cfx5" invoked from within "batch_interp eval ic_exec $args" (What a long error-message) I don't know what this message is trying to tell me and what I can do to make it work. Advices are welcome. Thanks a lot, greetings Christian |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
[snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 03:23 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
Refinement and boundary problems | Julie Polyakh | Siemens | 4 | December 16, 2001 08:17 |