|
[Sponsors] |
May 18, 2006, 04:04 |
About create new material
|
#1 |
Guest
Posts: n/a
|
When i simulate fluid flow,I do it succesfully by use water as the material,but use a material created by myself, Error ,as below: | ERROR #001100279 has occurred in subroutine ErrAction. | | Message: | | NAME_MOD: Error finding variable "DRHODP_T" The material I create as follow: LIBRARY:
MATERIAL: Aluminium Liquid Coord Frame = Coord 0 Material Description = Aluminium Liqid is used for foundry simulation Material Group = Constant Property Liquids Option = Pure Substance Thermodynamic State = Liquid PROPERTIES: Option = General Material DYNAMIC VISCOSITY: Dynamic Viscosity = 0.0012[Pa s] Option = Value END EQUATION OF STATE: Density = 2.371 [g cm^-3] Molar Mass = 27 [kg kmol^-1] Option = Value END SPECIFIC HEAT CAPACITY: Option = Value Reference Pressure = 1 [atm] Reference Temperature = 700 [C] Specific Heat Capacity = 950 [J g^-1 K^-1] Specific Heat Type = Constant Volume END THERMAL CONDUCTIVITY: Option = Value Thermal Conductivity = 217.7 [W m^-1 K^-1] END END END END Help me!Thank you in advance! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
[blockMesh] Include list of points | Hikachu | OpenFOAM Meshing & Mesh Conversion | 0 | June 20, 2011 09:03 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |