|
[Sponsors] |
|
July 6, 2020, 19:39 |
Mesh and convergence issue
|
#1 |
New Member
Bk
Join Date: Sep 2016
Posts: 10
Rep Power: 9 |
I have done meshing on rectangular plates having water flow at inlet from one side and outlet on another side.when I run my analysis for 1lpm flow in CFX it runs good and converge. But for 3 lpm it is not convergeing it fluctuate in range of 10-4.i am running for steady state. Heat transfer is also there.
|
|
July 10, 2020, 04:37 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,732
Rep Power: 143 |
This FAQ should help: https://www.cfd-online.com/Wiki/Ansy...gence_criteria
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Convergence | Centurion2011 | FLUENT | 48 | June 14, 2022 23:29 |
[snappyHexMesh] Snappy Hex Mesh - issue with smoothness of the model edges | olek.warc | OpenFOAM Meshing & Mesh Conversion | 1 | August 31, 2018 11:31 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[ICEM] issue occur after extrude 2D airfoil mesh and convergence problem in CFX | shiyun | ANSYS Meshing & Geometry | 4 | May 9, 2012 19:55 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |