|
[Sponsors] |
August 17, 2006, 09:36 |
import line/curve into sketch
|
#1 |
Guest
Posts: n/a
|
Hi there,
In DesignModeler, is there any way to import a closed curve to a sketch to perform a extrusion. For the purpose of parameter variation capability, I tried to import a solid with a given height and extract line from edge as foot print. But I am not able to put this curve into a sketch to make extrusion. Thanks Ahlo |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Import transient cfx-results for static structural analysis in Ansys WB 13 | Colt Seavers | ANSYS | 1 | August 11, 2011 06:01 |
[Other] Import autocad into Design modeller | lcea | ANSYS Meshing & Geometry | 1 | December 1, 2010 13:15 |
Import autocad into Design modeller | lcea | CFX | 0 | November 30, 2010 04:13 |
mesh missing after import in fluent | morteza08 | FLUENT | 0 | July 23, 2010 02:22 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |