How do I incorperate domain interfaces

Blitzwing · October 6, 2017, 10:02

I've modelled an open duct moving through an enviroment. However I need to simulate the presence of a fan in the centre if this duct so it performs a form of suction.

The current method I have been using is drawing a cylinder in DesignModeller in the centre of my duct. I name the two faces fan1 and fan2. With the wall as an opening.
I implement the domain interface to give a pressure drop between fan1 and fan2. The cfx setup seems successful but when it comes to solving I get an error.
The error comes from conflicting domains in 2 regions which I'm assuming is fan1 and fan2.

Can somebody provide reading material, video tutorial or advice on how to set this up adequately as I cannot find any information on how to do this.

Regards

ghorrocks · October 6, 2017, 18:12

A better way to do this may be to use a source term to model the effect of the fan. Then you do not need interfaces, and you have more flexibility in defining what you want to do with the flow. You can use this to model the entire fan performance curve (which is recommended if you do not know the exact operating point).

October 6, 2017, 10:02	How do I incorperate domain interfaces	#1
Blitzwing New Member Join Date: Aug 2017 Posts: 5 Rep Power: 8	I've modelled an open duct moving through an enviroment. However I need to simulate the presence of a fan in the centre if this duct so it performs a form of suction. The current method I have been using is drawing a cylinder in DesignModeller in the centre of my duct. I name the two faces fan1 and fan2. With the wall as an opening. I implement the domain interface to give a pressure drop between fan1 and fan2. The cfx setup seems successful but when it comes to solving I get an error. The error comes from conflicting domains in 2 regions which I'm assuming is fan1 and fan2. Can somebody provide reading material, video tutorial or advice on how to set this up adequately as I cannot find any information on how to do this. Regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pressure distribution on a wall	darazsbence	CFX	17	October 6, 2015 10:38
periodic condition and Rotary inner domain	aja1345	FLUENT	0	August 5, 2015 01:51
CFX domain comparison	Kiat110616	CFX	4	April 3, 2011 22:43
Numerical inaccuracy at domain interfaces in CFX	Chander	CFX	2	March 24, 2011 07:52
How to: Domain Interfaces	Neusier	CFX	8	March 22, 2011 06:34

October 6, 2017, 18:12		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	A better way to do this may be to use a source term to model the effect of the fan. Then you do not need interfaces, and you have more flexibility in defining what you want to do with the flow. You can use this to model the entire fan performance curve (which is recommended if you do not know the exact operating point).