|
[Sponsors] |
October 29, 2006, 02:19 |
2D setup and 2D profile data file in CFX10
|
#1 |
Guest
Posts: n/a
|
Hi! I am trying to simulate 2D heat transfer problem. Here, I have a few questions for my CFX setup as follows:
1. I generated one layer mesh by using extruded method. I think the mesh is OK. But, I am not sure what I need to setup more for 2D in CFX. Otherwise, how can CFX know this problem is 2D category? 2. My profile data, myProfile.csv, is as ===================================== [Name] wire heat [Spatial Fields] x [m], y [m] [Data] x [m], y [m], heat source [W m^-3] 0.1, 0.1, 3 0.2, 0.2, 4 … … ===================================== Is it correct setup for 2D profile? I highly appreciate if you can provide me any comments and tips. Thanks, Se-Hee |
|
|
|