 |
 |
 |
|
|
|
[Sponsors] | ||||
February 28, 2021, 05:27
|
Boundary conditions in a pipe
|
#1 |
|
New Member
Daria
Join Date: Feb 2021
Posts: 1
Rep Power: 0  |
Dear All,
I'm trying to proceed the simulation in a syphon. I'd like it to be transient simulation of two fluid - water and air. I tried to set opening in inlet with mass and momentum option - opening pres. and dirn and the same option for outlet but there is a warning "the solver failed with a non-zero exit code:2". The same warning occurs when I tried to set opening in inlet and boundary type in outlet. I have no idea where is a problem and how to fix i :< |
|
|
|
|
| Tags |
| boundary condition, cfx, transient 2d |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| Wrong multiphase flow at rotating interface | Sanyo | CFX | 14 | February 7, 2017 17:19 |
| Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 06:20 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Threaded Mode
