|
[Sponsors] |
Going from two phase boiling to above critical temperature? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 29, 2021, 18:54 |
|
#3 |
Senior Member
Erik
Join Date: Feb 2011
Location: Earth (Land portion)
Posts: 1,171
Rep Power: 23 |
Hi Glenn,
No, I have not asked ANSYS support about this yet. They are usually pretty slow to respond. Luckily my workaround was possible this time, but if I had a simulation which contained both a saturated mixture, and supercritical gas, I would not be able to simulate that. I'll ask support, and see if they have any worthwhile response. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two Phase Boiling Case in Microchannel | Muyiwa | OpenFOAM Running, Solving & CFD | 1 | February 13, 2020 17:23 |
Problem with phase change - Relating to TEMPERATURE | Kummi | OpenFOAM Running, Solving & CFD | 0 | August 5, 2019 01:12 |
Fixed temperature for one phase in VOF | Apiano | Fluent UDF and Scheme Programming | 2 | April 26, 2016 09:14 |
Ansys CFX problem: unexpected very high temperatures in premix laminar combustion | faizan_habib7 | CFX | 4 | February 1, 2016 17:00 |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |