[Nheni]

Dear Everybody,

Nowadays I am working on a problem where the results of a given simulation in Workbench are initial conditions of the next one, but sometimes, after a few phases the solver gives an error, namely “Incomplete line found”, and after that a “Size mismatch” error at the beginning of the simulation. The problem is the simulation does not start from the beginning of the simulation, but from the middle of the process. The error does not occur regulary, sometimes I start the same simulation again and it works properly. My workbench is fine, there is no fault or "incomplete line" anywhere.
I tried to define the .res file in the initial values and link the folders on the workbench, but the error occurs with both cases.
I browsed here after a similar experiences and I found it, but there are no solutions and the entries are old.
I'm using ansys 18.0, does anyone else have this problem? Is there a solution? Maybe this unreasonable message has been fixed in a newer version?
I don't think this is a setup error.

Thanks for the advices,
Nagy Henrietta