|
[Sponsors] |
Minimum mass and momentum RMS residual levels |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 2, 2021, 06:58 |
Minimum mass and momentum RMS residual levels
|
#1 |
Senior Member
Stuart
Join Date: Jul 2009
Location: Portsmouth, England
Posts: 735
Rep Power: 25 |
I was playing in CFX 2021 R2 by simulating turbulent airflow through a smooth pipe with a very low minimum RMS residual limit of 1E-21. I noticed that the mass and momentum RMS residual equations in CFX-Solver Manager were nicely decreasing but suddenly flat-lined at 1E-15, likewise the two SST k and omega plots. I do not recall CFX flat-lining residual levels in previous versions so is this something new? Again, I'm not aiming for a discussion about assessing convergence etc. as I was just playing about in CFX, but rather is a cap new in CFX.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error in liquidFilmThermo | fsch1 | OpenFOAM Running, Solving & CFD | 3 | July 3, 2019 09:40 |
Inconsistencies in reading .dat file during run time in new injection model | Scram_1 | OpenFOAM | 0 | March 23, 2018 22:29 |
Phi error in implimenting Kepsilon in DPMFoam | kinbean | OpenFOAM | 3 | December 19, 2017 17:11 |
sprayEngineFoam-T gas min/max = 204.507, 764.408 | ayhan515 | OpenFOAM Running, Solving & CFD | 2 | June 6, 2014 16:59 |
sprayFoam crashes | lukasfischer | OpenFOAM Running, Solving & CFD | 3 | July 14, 2013 11:08 |